How Can I Fix My Own Roof?

How Can I Fix My Own Roof?

There are a number of reasons to consider roof replacement for a roof. Roof setups are susceptible to a variety of damage, primarily because they tend to pool water and snow. This can lead to structural damage to the roof, leakage problems, and much more. Additionally, most new houses are built with slanted roofs of various types for the appearance and overall aesthetic effect that they have. A single ply roof is slanted and has a single layer of specialty shingles to cover it. These shingles are made from plastic or rubber and are specially designed to repel water and other items that may land on the roof. They will also reflect the heat on the roof as well, which in turn can help lower the temperature inside the home during the summer, resulting in lower air conditioning and cooling costs. This is an easy way to fix on your own.

Image result for roof fix

Myrtle Beach Do It Yourself Roofing

Multiple ply roofs are generally sturdier than single ply versions. They consist of alternating layers of a flat rolled-out mat similar to that in single ply, and asphalt or another protective coating. The top of the multiple ply roof tends to be layered with small stones or gravel to help provide further protection against damage. These roof types are often best used in areas where there is likely to be exposure damage. These too can be done at home only you need some ideas and a better study of the measurements.
Remove the plies of the flat roof by forcing into them with a spade. Plies are the layers of felts, fabrics, and mats that make up roofs. Always stand on a firm section of the roof and wear long pants, long sleeves, and safety glasses. Orient the spade at a 30 to 40-degree angle to the roof and start pushing a spot in the middle of the roof repeatedly. Grip the back of the handle with your dominant hand and use your non-dominant hand to hold the handle ¾ of the way from the back.

Measure Your Roof Correctly

Attaching the EPDM membranes are the next step. Measuring them properly, width to width, length to length and cutting off the excess, Next is to pull off the sticker, the glue part will get attached on the subsequent membranes.
Layering properly the membranes are the hardest job. You have to be still and sometimes might need an extra hand or two. Layering the membranes should be done while they are wet, once the glue gets oxidized it lacks its adhesiveness and might disturb you and could ponder your hard work.
Attach the EPDM both sides and you are good to go.